How To Put Up Board And Batten Siding

The next panel will fit over the edge of the previous one disguising the nailing strip and lock securely into place.

How to put up board and batten siding.

Line up the panel with the edging and use screws to secure it in place on the nailing strip. Use a 4 foot carpenter s level to keep the boards vertical. Fill the channel of the corner by nailing down a strip of board 2 wide. This kind of siding is done vertically and installed with the use of wide boards normally 6 to 8 inches in width arranged alternately.

Prepare the walls as you would for other wood sidings by applying building wrap self stick flashings at the. When putting up the boards pay careful attention to the growth rings. On each wall measure. For larger boards up to 10 use two nails on the edges of the boards.

Push a strip of finish trim into the channel of the corner over the board and nail. Cut off the locking leg of the first panel and snaplock punch the edge at 12 intervals. Install water table boards. The batten overlap should be large enough to cover the nails that are used to attach the boards.

The seams will be covered with the battens which are usually 2 to 3 inches wide. Like many types of siding you ll start installing the board and batten panels from one side. You nail through the batten to only one edge of the board and let the other board edge float under the next batten he writes. How to do it prep walls.

The boards will typically try to cup as they dry. In addition to applying stain to both sides and all edges nailing both boards and battens correctly also is key. All around the house install a 1x6 or wider water table with its bottom edge 2 inches below. For smaller boards up to 6 you can nail through the centers of the board and battens.

Board and batten siding is a home improvement project that can give your home a facelift.