How To Repair Warped Vinyl Siding

Remove the nails underneath and simply pull down the siding.

How to repair warped vinyl siding.

Now measure the length of the siding. Pull out enough nails so the end. Subscribe to this old house. Pry the end of the board with a chisel or other tool from the side of the building.

Pull down on the siding to disengage it from the course below then remove the damaged piece of siding. Repeat steps 4 and 5 to remove the remaining damaged siding panels. Wedge a wooden block in. Use a hammer to pull the nails holding the first course of damaged siding to the wall.

Once buckled vinyl siding is done. Inspect the area behind. With the new siding connect it on the exterior wall and reinforce it with some nails. Pry the nails from the warped area of the board with the back end of a hammer.

Insert this tool beneath the bottom edge of the overlap and pull down while sliding the tool horizontally. Slide your hand along the wall to disengage the butt bottom edge of the siding. Using a saw or a rasp shorten the board so that only 1 16 of space leads up to the next board and then refasten the board in place. Slowly lift up the end of the board making sure to not damage any of the material underneath.

Ask this old house general contractor tom silva helps a homeowner repair sections of his vinyl siding that have holes. The vinyl siding on the house has warped leaving a gap. I am worried that critters will get in. First remove the nails from the warped boards or cut them using a hacksaw blade.