How To Replace An Awning On A Camper

We then secured the polly cord with screws to the roller.

How to replace an awning on a camper.

Cut your patching material by using fabric scissors or a knife. Removing the roller 1. Your step by step diy guide step 1. Start by measuring your awning from the inside of each cap.

Afterward head to a home hardware store and purchase an appropriately sized replacement fabric. Choose a fabric replacement measure for the correct awning replacement fabric. Replacing the vinyl awning on a rv or camping trailer with less work using just one person. You don t need to extend it all the way only about a.

Purchase a replacement awning fabric. If you prefer to use waterproof glue let it dry. Take measurements down both sides making sure the awning is stretched reasonably tight and not folded or creased and mark the length with a pencil or non permanent marker. If you stitch your mending material to your camper s awning ensure that you find no visible or loose strings.

The steps to replace the rv awning are almost the opposite of the removal. The next step is to fix the upper arms of the awning in place by sliding them in place. You can stitch or use an adhesive glue waterproof like in the 3rd step to stick your mending material to your awning. The next step is after adjusting the tension of each arm.

Get onto a step ladder and find the bolts holding the. Loosen the awning bolts roll the awning out from the rv. Measure the width of the current fabric not the roller length but fabric length and transfer that measurement to the new awning material. If you thought replacing your rv s main patio awning was out of your league as a do it yourselfer watch this first and you just might change your mind.

If you take a close look you ll notice that the fabric is tucked. We used the old awning as our work space to prevent scuffing or damage to the new awning. Replacing rv awning fabric. To do so measure from the center.

We carefully unfolded located front and back and slid the new rv awning with the attached polly cord into the awning roller. Remove the bolts holding the awning to the top of the rv. Next use the tension knobs on either side of the awning to adjust the tension arms. Use your one hand to keep the awning tight during this step.

Remove the screws holding the fabric to the track.