How To Stagger Vinyl Siding

Well done seams can also preserve the longevity of your siding.

How to stagger vinyl siding.

Different siders do it different. Whatever your measurement is take at least 1 4 or 1 8 on both sides for the panel to slide back and forth. Everything else is fine. Everything is great except i did not stagger the panels.

Eaves treatment measure from the soffit to the base of the upper lock on the previous course. You need to leave at least 1 4. In most other siding options the seams are a point of sealant. Push the siding into the utility trim or.

Some will stair step it others alternate the lap up the wall. A properly done seam will help keep harmful moisture out and increase the insulation of your home. Siding boards usually come in uniform lengths so the best way to achieve a random stagger pattern is to cut the first board of each row a different length before installing it. With time you will figure out what looks good and does not waste anymore material then needed.

If it doesn t work for that row save it. Cut the panels to length with tin snips. When cutting vinyl siding it s usually to go into a corner. You can often get great stagger patterns by using the off cut from a row you just finished to start the next one.

Position a nail at the top of the upper slot on both sides of the corner post leaving a gap of approximately 1 32 0 8mm between the nail heads and the corner posts. How to stagger vinyl siding joints 1. Install the first panel by pushing the panel s buttlock up into the locking tab on the starter strip. If you don t cut your siding short when it expands in the summer it s going to buckle.

In vinyl and aluminum siding it s the point that allows for expansion and contraction. The siding laps should be staggered. The nails are in but not to tight. All the panels are locked in.

I installed vinyl siding on one side of my house. The starter strip is level. Place the corner post in position allowing a 1 4 6 4mm gap between the top of the post and the eave or soffit. As long as you are staggering them according to recommended specs it really does not matter what others are doing.

I have a line straight down the center showing where each of the panels overlap. Do you stagger the panels for aesthitic reasons or is there a.